All Things That Fly Interview

Completed flux rings, magnets, shafts and fan housings for HK-2221 motors prior to final assembly.

Another short video that shows the winding of a phase on an HK-3026 stator close up.

Video that shows the final assembly and test of an HK-2221-6 motor.

Video showing the balancing process used on all Scorpion motors.

Video that shows the final packaging and boxing of newly completed HK-2221-6 motors

Cases of HK-3026 motors ready to ship to heli pilots all around the world!

These are my motors! If you look close you can see the "Innov8tive" name on the side of the boxes.

Prototypes of the new 12-cell ESC's. 90 amp in front, and 130 amp behind.

Custom extrusions and stamped base that go together to make the heat sink case for the 12-cell 130 amp ESC.

FET's mounted upside-down allow the metal tabs direct contact the heatsink case for maximum heat dissipation.

An 18 amp brushless ESC that shows the 12 different SO8 style FET's on the circuit board.

New 55mm motor family on display at the Shanghai Model Show. 5525 models in back, 5535 in the middle, and 5545 up front.

Scorpion S-5535-14 motor.

Prototype of the new Scorpion 15-cell
250 amp Speed Controller.

Another view of the 15-cell (60 volt) 250 amp Speed Controller

View of the 6-story dorm facility from Georges office. In the foreground are the 2 main factory buildings connected by a covered walkway.

Typical Dorm Room for Workers.

Heat AND Air Conditioning!

Factory Workers Dining Hall.

Office Staff Dining Hall.

(Page 4 of 5)